1. Compatibility

1.1. Network

As shipped from the factory, the MultiSense S27 is configured to communicate on a network with a Maximum Transmission Unit (MTU) size of 7200 bytes. On Linux-based systems the MTU settings of a network interface can be checked by issuing the following command. Note that INTERFACE_NAME should be replaced with the name of network interface in question, most likely eth0.

/sbin/ifconfig INTERFACE_NAME

The output of this command will include information about the current MTU setting of the network interface.

The MTU setting is notes in the example output below, which was generated by the command /sbin/ifconfig eth0:

eth0 Link encap:Ethernet  HWaddr 3c:97:0e:29:85:22
    inet addr:10.66.171.20  Bcast:10.66.171.255  Mask:255.255.255.0
    inet6 addr: fd80::3897:dff:1e29:8522/64 Scope:Link
    UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1               (1)
    RX packets:70029406 errors:0 dropped:0 overruns:0 frame:0
    TX packets:30272801 errors:0 dropped:0 overruns:0 carrier:0
    collisions:0 txqueuelen:1000
    RX bytes:69790232908 (64.9 GiB)  TX bytes:35517400326 (33.0 GiB)
    Interrupt:20 Memory:f5200000-f5220000
1 Line showing original MTU size of 1500

Verify that the network hardware supports the necessary frame size by explicitly setting its MTU to 7200:

sudo /sbin/ifconfig INTERFACE_NAME mtu 7200

Where INTERFACE_NAME is again replaced by the name of the network interface in question.

Check that the change was successful by querying the settings again:

/sbin/ifconfig INTERFACE_NAME

The output should now reflect the updated MTU setting:

eth0 Link encap:Ethernet  HWaddr 3c:97:0e:29:85:22
    inet addr:10.66.171.20  Bcast:10.66.171.255  Mask:255.255.255.0
    inet6 addr: fd80::3897:dff:1e29:8522/64 Scope:Link
    UP BROADCAST RUNNING MULTICAST  MTU:7200  Metric:1              (1)
    RX packets:70029406 errors:0 dropped:0 overruns:0 frame:0
    TX packets:30272801 errors:0 dropped:0 overruns:0 carrier:0
    collisions:0 txqueuelen:1000
    RX bytes:69790232908 (64.9 GiB)  TX bytes:35517400326 (33.0 GiB)
    Interrupt:20 Memory:f5200000-f5220000
1 Line showing new MTU size of 7200

1.2. Software

1.2.1. ROS Driver

The most recent ROS driver release is designed to be fully backwards compatible with all released firmware versions, back to and including the 2.0 firmware release. If the ROS driver detects an older firmware version, only the appropriate topics and capabilities (including dynamic_reconfigure variables) will be presented.

1.2.2. Device Firmware

All v5.X firmware relases are designed to be fully backwards compatabile with older ROS driver releases. To get access to the most recent features it is reccomended you use the latest ROS driver release with new firware.

1.3. Hardware

The latest ROS driver release and documentation support all versions of the Carnegie Robotics MultiSense product line including: MultiSense SL, S7, S7S, S21, KS21, S27, and S30. For more information about the various MultiSense products please visit https://carnegierobotics.com/products/